User's Manual

IS-SNAKE DevKit Setup Manual
CTR-06-0193-003-B 12  2015 Nintendo
Released: April 6, 2015 CONFIDENTIAL
6.5 Attaching the Ferrite Cores
Follow the procedure below to attach the ferrite cores.
Attach a ferrite core to the USB cable.
Loop the cable through the core twice as
shown in the figure, leaving about 5
centimeters or 2 inches from the USB-B
connector.
Attach a ferrite core to the AC adapter
cord.
Loop the cable through the core once as
shown in the figure, leaving about 5
centimeters or 2 inches from the DC
connector.
When using the debug controller, also
attach ferrite cores to the controller cable.
Connect the cores as shown in the figure.
Starting from the connector, leave a gap
of 5 centimeters or 2 inches, then attach
the first small ferrite core with two loops
of cord. Next attach the large ferrite core,
again with two loops of cord. Lastly,
attach the second small ferrite core close
to the controller, with just one loop of
cord.