User's Manual

IS-SNAKE DevKit Setup Manual
CTR-06-0193-003-B 14  2015 Nintendo
Released: April 6, 2015 CONFIDENTIAL
6.7 Replacing the Batteries
If the following message appears when using the software or on the HDMI output screen, replace the
batteries as described under Section 5.6 Inserting the Batteries: "The battery might be missing or dead.
Replace the batteries."
6.8 Connecting the Hardware
Follow the procedure below to set up the hardware.
Make sure that the power switches of the IS-
SNAKE-BOX units are in the OFF position.
Connect the controller to the IS-SNAKE-BOX.
Connect the L-shape connector to the controller
part, and insert the straight connector into the
CONTROLLER port on the front of the IS-
SNAKE-BOX. Firmly push the connector until
you hear it click into place.