User Manual

PCS In-Building Booster Installation Manual

Page 2 of 5

All brands and trademarks are the property of their respective owners.

Rev 1 D000005

Designed and manufactured under license from Motorola, Inc. in the USA

Section # 3 Parts List

Item Qty Description

1 1 Cyfre

™

In Building PCS Booster

2 1 Cyfre external antenna with 15ft low loss cable

Cyfre interior antenna with 4 meters of low loss antenna cable

(Picture for illustration purposes only)

Cyfre 120 VAC power supply 1 ampere

Cyfre 4 meter low loss antenna cable with “N” connectors

Section # 4 Selecting a Suitable Location To Install The Booster

∇ Locate a suitable indoor dry place on a flat surface near an electrical power source that is well ventilated. The booster’s

location should be easily accessible and mounted away from moving parts, excessive heat or moisture.

∇ The exterior antenna must be mounted the above the roofline of the building with a clear view of the surrounding area and

at a distance that can be reached from the supplied antenna cable.

∇ Antennas must be mounted a minimum distance of 20 cm (7.87 inches) away from any person.

∇ When selecting a proper location for the interior antenna a minimum distance of 12 feet (3.64m) distance away from the

amplifier.

∇ Antennas cannot be located in the same area and must

be mounted at different heights and separated by a wall or

ceiling to insure optimum performance. Positioning antennas too close together may result in amplifier failure and void the

warranty.

∇ Exterior antennas can only be installed outdoors. Under no circumstances can an exterior antenna be installed indoors,

Doing so may result in amplifier failure and void the warranty.

∇ If the signal level is increased in some areas but not others, it may be due to location of the interior antenna or building

materials acting as a shield for the radio signals. This can be overcome by re-positioning the interior antenna or, the use of

2 internal antennas in conjunction with a very low loss high quality splitter. Note that the use of multiple interior antennas

require that they be placed at least twenty five (25) feet apart and should be separated by gypsum clad, masonry or

metal constructed wall.