User guide

PRESET MODE (connued...)

MORPH: The SHAPESHIFTER module allows you to morph between the current panel parameter sengs and

the sengs stored in the currently selected preset. To acvate this ability, press the MOD A/MORPH buon

(second from boom buon to the le of the rotary encoder). The LCD display will now show “Morph NN”

(where NN is the currently selected preset number) and “PnL->Pst” (or “Pnl<-PsT”). The currently selected

preset number can be changed by turning the rotary encoder. The parameter values actually used by the mod-

ule in this situaon will be a blending of the current panel sengs and the parameters stored in the currently

selected preset. The relave blending is controlled by the MOD B control (and MOD B input). When the MOD B

control is fully counter clock-wise the actual parameters will be the same as the panel sengs, whereas if the

MOD B control is fully clock=wise then the actual parameters will be those from the currently selected preset.

When the MOD B control is somewhere in between, the actual parameters will be a blending of the two.

There are two excepons to this blending: the INT. SYNC and PERC. MODE sengs are always set to the panel

conguraon. The preset values for this buons are ignored. Note that the currently selected preset can be

changed on the y using the rotary encoder, allowing the sounds to be rapidly changed during a performance.

With the MOD B knob turned all the way clock-wise (so that the blending is completely to the preset values)

this allows a quick way to audion the presets before loading them.

STEP: The SHAPESHIFTER module also has the capability of stepping through the presets in response to triggers

sent to the SYNC input. To acvate this ability press the SYNC/PULSE/STEP buon (second buon from the top

to the le of the rotary encoder). The stepping is done on presets in a user-denable range of preset numbers

(the Begin and End presets). The STEP mode has seven dierent sengs, accessed by turning the rotary en-

coder. These are described below:

Fwd : NN when this is selected, press the SYNC/PULSE/STEP buon to turn on the stepping acon. Each

trigger received by the SYNC input will step the preset to the next highest number. The LCD display will change

to show “Fwd *NN”. The * indicates that stepping is live. To disable the stepping press the SYNC/PULSE/STEP

buon again.

Rev : NN this is the same as the Fwd seng except that each trigger will step to the next lower preset.

Fw/Rv: NN in this mode the stepping will rst increase the preset number unl the end preset number is

reached, and then step downwards unl the beginning preset number is reached, and the cycle repeats.

Rand : NN in this mode a random preset number in the range is selected on each trigger.

MOD B: NN in this mode the preset number selected on each trigger is set by the posion of the MOD B knob

(and by the MOD B input). This allows an external input to select or sequence the presets on each trigger.

Begin: NN when this is selected, press the SYNC/PULSE/STEP buon. The LCD display will change to show

“Begin? NN”. In this state you can turn the rotary encoder to select the starng preset number for the stepping

sequence. Once you have chosen the desired starng preset number, press the SYNC/PULSE/STEP buon again

and use the rotary encoder to select one of the other sengs.

End : NN in a manner similar to the Begin seng, this allows you to select the endng preset number for the

stepping sequence.

Div: N in a manner similar to the Begin seng, this mode sets the number of SYNC pulses per step. It is used

when you want to repeat a preset for a number of sync pulses before stepping to the next one. N can range

from 1 to 8. When set to 1, the preset will step on every sync pulse.