User Manual

● NEW FEATURE : Delayed load . When on the LOAD page, long-press the desired preset button
to delay it from loading until the current pattern completes the cycle on Track 1.
● NEW FEATURE : Muted tap entry mode . When in TAP Recording Mode, you can press the
PROB button to toggle muting of your taps. The ABCD buttons will turn yellow when muted.
● NEW FEATURE: Step Edit Mode . Previously, only ratchets could be edited on a per-step basis,
but now Gate, Delay and Probability (along with ratchets) can also be edited using the new Step
Edit Mode, accessed by long-pressing the EDIT button. For full details, see Step Edit Mode .
● FIX: Track Probability is now applied to the current position, and will not randomize
individual ratchets.
1.11 (2019-10-10)
● FIX: Additional filtering on Clock input to handle imprecise clock pulses.
1.10 (2019-08-14)
● NEW FEATURE : RUN Mode (as an alternate to RESET Mode).
In RUN Mode, the sequencer will only advance when the RST input has a high gate. In this
mode, Steppy will also reset when the gate goes high.
Hold the SAVE RST button on boot up to toggle between RUN and RESET modes (the setting
is saved across boots). On the SELECT page, you'll see the SAVE RST button light yellow if
RUN mode is enabled.
This feature is discussed in the RESET (RST) IN jack description in the Inputs & Outputs
section of this manual.
● FIX : In either RUN or RESET mode, any gate that arrives at the RST jack a few milliseconds
after the rise of a clock pulse (i.e. when the clock is still high) is automatically compensated for,
allowing step 1 to fire immediately.
● FIX: Manually pressing RST from the SELECT page will now immediately reset to step one
rather than waiting for the next clock pulse.
V1.00 (2018-10-18)
● Initial release
 
Steppy 1U Manual 38