User Manual

Connecting a Stereo Line In 1U to a Palette Case’s ¼” Jacks 
The Stereo Line In 1U module ships with a ribbon cable for connecting to a pair of ¼” TRS audio
jacks — either those built-in to the 2nd generation Audio Jacks Board installed in Intellijel 7U cases ;
an Intellijel Palette case, or those contained within the separately available Stereo Out Jacks 1U
module.
To connect the Stereo Line In 1U module to the jacks installed in your Intellijel Palette case:
1. Connect one end of the supplied ribbon cable to the keyed 6-pin connector on the Stereo Line
In 1U module and the other end to the single keyed 6-pin connector on the Palette case’s
built-in circuit board.
Audio arriving at the corresponding pair of ¼” jacks is sent through to the Stereo Line In 1U
module for patching into your eurorack system at the correct voltage levels.
Stereo Line In 1U System Manual 10