User Manual

Connecting a Stereo Line In 1U to the ¼” Jacks on a 7U Case 
The Stereo Line In 1U module ships with a ribbon cable for connecting to a pair of ¼” TRS audio
jacks — either those built-in to the 2nd generation Audio Jacks Board installed in Intellijel 7U cases ;
an Intellijel Palette case, or those contained within the separately available Stereo In Jacks 1U
module
To connect the Stereo Line In 1U module to the jacks installed in your 7U case:
1. Determine whether your case uses a 1st or 2nd generation Audio Jacks Board.
1st generation boards (included with cases built before early 2019) have a single connector
along the bottom. 2nd generation boards have a large shrouded header flanked by two smaller
shrouded headers, flanked by two link connectors.
IMPORTANT: You can only connect the Stereo Line In 1U module to 7U cases with 2nd
generation Audio Jacks Boards. If you have a 1st generation board, you can purchase a 2nd
generation board to replace your original Audio Jacks Board.
2. Connect one end of the supplied ribbon cable to the
keyed 6-pin connector on the Stereo Line In 1U
module and the other end to one of the two keyed
6-pin connectors on the Audio Jacks Board .
Audio arriving at the corresponding pair of ¼” jacks is
sent through to the Stereo Line In 1U module for
patching into your eurorack system at the correct
voltage levels.
 
Stereo Line In 1U System Manual 8