user manual

WIRELESS NETWORK IP CAMERA User’s Guide

6. PTZ port number (not useable in Wireless Camera)

7. ETSP port number

Set the port number for ETSP [Event Trigger Setting Program]. (Default is “11000” and users can

select from 8000 to 65535. For the detail of ETSP, please refer to the ETSP manual.)

8. 1st, 2nd DNS Server Address

To map between IP address and domain name, you should enter you DNS server address.

If a user set the DNS server into the camera, users can configure the SMTP server, FTP server, and

NTP server with domain names.

9. SMTP server

You need to specify your SMTP Server if you want to use any of the camera's email features. Other

than that, it can be left blank.

10. Use SMTP Authentication

If you need user authentication for accessing the SMTP server, check this box. and enter your ID and

password for your SMTP server. Realm should be left blank, and authentication should be set to

- Authentication method: Choose the SMTP authentication method.

- ID: : Enter the user ID for SMTP authentication.

- Password: Enter the user password for SMTP authentication..

- Realm: : Enter the Realm for SMTP authentication.

CAUTION

Be careful not to use the same port number for Image Transfer Port Number and Upgrade port

number. If it is duplicated, a warning message will appear.

DNS (Domain Name System)

DNS (Domain Name System) is used to map between IP address and domain name. Every network

device connected to the Internet has an IP address that is used instead of its domain name.

Common users are not familiar with IP addresses but the domain names.

If a user accesses a certain network device with its domain name, a DNS server translates the

domain name into an IP address .