user manual

WIRELESS NETWORK IP CAMERA User’s Guide
74
J. Reinstating the Factory Default Settings
This information explains how to set the default settings in the Wireless Network IP Camera. In
certain circumstances it may become necessary to restart or reinstate the Factory Default settings for
your Wireless Network IP Camera: This is performed by pressing the Reset Button, or using the
Hyper Terminal Setting. Follow these instructions to reinstate the product factory default settings
By Pressing Reset Button
① Using a paper clip or any sharp pin, press the reset button on the backside of Wireless
Network IP Camera.
② Switch off the Wireless Network IP Camera by disconnecting the power cable.
③ Press and keep the Reset Button pressed, and then reconnect the power supply cable.
Keep the Reset Button pressed until the Operating Status LED (Green) blinks three times.
(Note that this may take up to 10~15 seconds), then release the button.
By Using the Web Browser (System Configuration Page)
You can restore the factory default values in the Administrator Menu, System Configuration,
Click on RESTORE DEFAULTS. See image below:
.