User`s manual

112
page or use the “Site Survey” function to automatically
search for an available access point and associate with it.
Function: You can select “Auto”, Enable” or
“Disable” to manually configure the wireless function.
 Auto – “Auto” is the default setting of the print server. At this
mode, the print server will automatically decide to enable or
disable the wireless function. When the print server starts up, it
will auto-detect if the LAN port is connected to an active
network by an Ethernet cable. If this is the case, the print
server will run in Ethernet mode. If the print server is not
connected to an active network by Ethernet cable, the print
server will run in wireless LAN mode.
Users can plug the Ethernet cable to the print server at the first,
after configuring the print server features and wireless settings;
they can unplug the Ethernet cable to enable the wireless
connection. It makes the configuration much easier without
creating the wireless connection in advance.

Enable – Enable wireless function only, the print server’s
wireless LAN will be always enabled and Ethernet will be
always disabled.
 Disable – Disable the wireless function, the print server’s
wireless LAN will be always disabled and Ethernet will be
always enabled.