User manual


automatically to this port. For example, when you make Port 3 of a VLAN part of VLAN ID 2,
the PVID “2” will be assigned automatically to Port 3.
Also, settings in VLAN, Port Aggregation and Mirror are co-dependent. Be sure the settings

PVID (from the VLAN screen)
When the VLAN-enabled switch
receives a tagged packet, the
packet will be sent to the port’s
default VLAN according to the

receiving port.
Port: Ports 1 – 8.
Egress: Select “Tagged” in the
drop-down menu to enable the
PVID checking and tag inserting
of one port; select “Untagged”
to cancel. For example, if an
Egress tagged port receives an
untagged frame, it will be
transmitted as a PVID tagged
frame. The table below presents
details of tagging status.
PVID:
Only tagged: “Enable” blocks all untagged packets from accessing this port; “Disable” allows
all packets to access this port.
Aggregation (Trunking)
To set up the port trunk groups, put the
selected ports’ numbers into the same
Aggregation group. You can choose up

settings.
There are three aggregation modes to







the packets.
10
MANAGEMENT
Untagged Tagged
Packet Frames In Packet Frames Out Packet Frames In Packet Frames Out
      
      
      