User manual

1. INSTALLATION
Front Panel
The front panel of the Gigabit Ethernet Managed
Switch presents the LED indicators, as shown in
the image at right and described in the table below.
NOTE:

disables this corresponding copper port.
Rear Panel
The rear panel presents the eight ports, SFP slot, power receptacle and Restore button.
Port Operation
Auto-negotiation allows the ports to run in one of the following operational modes.
NOTE:


5
INSTALLATION
NOTE: The image depicts only the LED section of the front panel.
LED Status Indication/Operation
PWR Steady green The switch is on.
Blinking green The switch is off.
1000M Steady green The port is connected at 1000 Mbps.
Blinking green A valid link has been established, and there is data being
transmitted or received.
Off No valid link is currently established at this port; or the port
is connected at 10/100 Mbps.
10/100M Steady green The port is connected at 10/100 Mbps.
Blinking green A valid link has been established, and there is data being
transmitted or received.
Off No valid link is currently established at this port; or the port
is connected at 1000 Mbps.
Media Speed Duplex Mode
  
Half duplex
100 Mbps Full duplex
Half duplex
1000 Mbps Full duplex
  