User manual

Restore Default Button
You can use this button to reset the switch or restore it to its factory default settings. To reset
the switch, press the button once; to restore factory default settings, press and hold the button
in for three seconds.
Power Receptacle
To be compatible with electrical standards around the world, the Gigabit Ethernet Managed

your source of electricity is within this range.

rear panel of the switch and plug the male end into a wall socket or other electrical outlet.

Placement
The switch can be placed on your desktop or mounted in a rack. Prior to placement and
installation, however, be sure that
• the environment is well-ventilated – a minimum space around the unit of 25 mm is
recommended;
• the switch and relevant components are away from sources of electrical noise, such as
 
• the environment is protected from high levels of humidity.
Desktop Placement
Position the switch on a level surface that can support the weight of the unit and any relevant
components.
Rack Placement
Rack mounting enables orderly installation in cases where a number of networking devices
need to be installed in the same area. Brackets and screws are included with the switch.
1. Disconnect all cables from the switch.

3. Position one of the mounting brackets over the mounting holes on one side of the unit.
4. Screw the bracket securely in place.
5. Repeat this for the other side of the unit.
6. Slide the unit into the rack and secure it with suitable screws.
7. Reconnect all the cables.
Cable Connections
Crossover or straight-through cable: All the ports on the switch support Auto-MDI/MDI-X
functionality. Either straight-through or crossover cables can be used to connect the switch

Category 3/4/5/5e UTP/STP cable: For a valid connection and optimal performance, it is
vital that appropriate cables be used that correspond to the different transmitting/receiving
speeds. To choose a suitable cable, refer to the following table.
6
INSTALLATION
Media Speed Wiring
  
  
  
  
   instructions.