User manual

28
CONFIGURATION
RAID 1 (Mirror)
AfterinitializingtoRAID1(Mirror),youshouldseeascreensimilarto
theoneshownbelow,inwhichtotalsizeisthesameastheoriginal
harddisksize.IfthesizesofDisk1andDisk2aredifferent,thenthe
RAID1totalsizewouldautomaticallyselectthesmalleroneasitssize.
However,it’srecommendedthatyouusethesamesizewhenchoosing
RAID1.Thedevicewillautomaticallyrunresyncingafterformatting,
andtheRAID1congurationwillnowbeoperational.
When a new HD is installed to replace a broken one in RAID 1 (Mirror),
theNASwillsettoDegradedmode.A“Recall”buttondisplaysinthe
StatuscolumnofVolumeStatus(below),andonlyHDD-Aisavailable.
Click“Recall”toaddHDD-BinRAID1.Whenthewarningmessage
displays,click“OK”tocontinuetheaddition.NOTE: This will re-partition
andre-formatthenewharddisk/drive,andalldatainsidewillbelost.