User manual

5
HARDWARE INSTALLATION
hardware/iNStallatioN
Toinstallaharddisk/driveintheGigabitSATANAS2TB,followthe
steps below.
1. ShutdowntheNASandunplugthepowercordfromtheACoutlet.
2.Removethescrewsthatsecurethehard
 disk/drivecovertothesideoftheNAS
 deviceandslidethecoveroff.
3.Slidetheharddrive/diskinsidethe
 coveryoujustremovedfromtheNAS
 device.
4. Connect the SATA cable and hard
 disk/drivepowercordbetweenthe
 harddisk/driveandtheNAS.
5.Re-positiontheHDD/coverassemblyonto
 theNAS,beingcarefulnottocrush(and
possibly damage or disconnect) the SATA
cable and HDD power cord. The hard
 disk/driveinstallationisnowcomplete.Turn
on the NAS.