User manual

6
WPS
Start WPS function or reset the router to factory default
settings (clear all settings). Press this button and hold for
over 10 seconds to restore all settings to factory defaults,
or press this button for less than 5 seconds to start WPS
function.
ON/OFF
Switch the button to activate or deactivate the router.
DC in
Connect the supplied power adapter to this mini USB port
to charge the battery.
RJ45 Port
Local/ Wide Area Network (LAN/WAN) port.
1-6 Charging the Battery
Before using the router, the battery needs to be charged. Charging
the battery takes about four hours.
1. Remove the battery compartment cover on the back of the
router, insert the included battery (if it’s not already in place),
then replace the cover, sliding it until the lath snaps securely
back in place.
2. Plug the included power adapter into an AC outlet or an
automobile’s auxiliary power outlet, then connect it to the mini
USB port on the router (DC In). While the router battery is
charging, the PWR/CHG LED lights orange, then turns green
when the router battery is fully charged.