User manual

 16‐PortGigabitEthernetPoE+Web‐ManagedSwitchwith2SFPPorts
11

4 CONNECTIONTOTHESWITCH
4.1 CONNECTINGCOMPUTER
UsestandardCat5/5eEthernetcables(UTP/STP)toconnecttheswitchtoendnodesasdescribedbelow.Switchports
willautomaticallyadjusttothecharacteristics(MDI/MDI‐X,speed,duplex)ofthedevicetowhichtheyareconnected.

Figure7‐PCConnect
TheLNK/ACT/SpeedLEDsforeachportareilluminatedwhenthelinkisavailable.
4.2 HOWTOLOGINTOTHESWITCH
AstheswitchprovidesWeb‐basedmanagementlogin,configureyourcomputer’sIPaddressmanuallytologontothe
switch.Thedefaultsettingsoftheswitchareshownbelow.
Parameter DefaultValue 
DefaultIPaddress  192.168.2.1 
DefaultUsername  admin
DefaultPassword  1234
Logontotheconfigurationwindowoftheswitchthroughfollowingsteps: 
1. ConnecttheswitchwiththecomputerNICinterface. 
2. Powerontheswitch. 
3. CheckwhethertheIPaddressofthecomputeriswithinthisnetworksegment:192.168.2.xxx(“xxx”rangeis2‐
254);forexample,192.168.2.100. 

