User manual

- 9 -
2.4 Network Video Server
Video Input: To input video signal through a coaxial cable
Video Output: To output video signal through a coaxial cable.
On Air LED (Green): This LED indicates the Video Servers operating status. Once power is
supplied, the LED lights and then blinks once every second as long as the video is transmitted
on the network during normal operation. When there is no video transmission, the LED stops
blinking. Under an event-trigger situation, the green LED becomes red and blinks rapidly. During
simultaneous operation of event-trigger capture and video monitoring, it blinks rapidly and
alternates between red and green. When you click "Video Server off" in the administrator’s
menu, this green LED turns yellow, which shows that the IP Video Server has stopped
transmitting video and audio.
Network Activity LED (Yellow): This LED indicates network activity. When lit, the network is up
and running; when off, the network is down and not working.
Power LED (Red): Once power is supplied to the Video Server, the red LED will light.
Power Connector: Only use the supplied AC adapter to avoid any possible damage from
electric shock.
RESET: Restore the factory default settings.
I/O Connector: To connect external devices such as infrared sensors, alarms or motion
detectors (refer to Appendix F: I/O Connector).
Power I/O Connector
Ethernet
Speaker Out Microphone In
Mini-DIN Connector
Reset
Video Input
Video Output
Power LED On Air Network LED