User`s guide

NETWORK IP CAMERA User’s Guide
④ Enter the IP address, Gateway address, Subnet Mask address, DNS Server address and Server IP
address that is assigned from network administrator in blank of “New IP address”, Gateway
Address and others. (When the addresses are not assigned properly, you cannot access Network IP
Camera remotely. Even on the local network, you are not able to access if you do not assign an IP
address to Network IP Camera properly).
⑤ Server IP Address represents an IP address of PC, which is being executed upgrade program when
you have Network IP Camera upgraded. (Please refer to Chapter ’E Updating Network IP
Camera’s newly upgraded Program).
After entering all addresses for Network IP Camera, click on “Change Network Configurations”
button.
⑥ The Success message shows up if all the
information is set up properly. Then click
“OK”button.
16
NOTE
After changing Network Configuration for Network IP Camera, It will take a little time to
reboot Network IP Camera
b
y itself so that you may access Network IP Camera’s
Homepage after checking the Operator LED blinks.