User`s guide

NETWORK IP CAMERA User’s Guide
Gateway inet (g) is the gateway address of Network Camera.
⑥ Type ‘c’ key to change the network configuration in [Network IP Camera Boot] prompt. If you
type ‘c’ key, Network IP Camera shows you the information you can change its values and the
current assigned values. You can change as the following figure.
⑦ When you terminate hyper-terminal program after you changed network configuration, hyper-
terminal program asks you whether you save the session. If you save the session, you can re-use
the hyper-terminal. To re-use the session you saved, click Start --> Programs --> Accessories -->
Communications --> HyperTerminal --> Network IP Camera.. ht in the case of Windows 2000.
21