User's Manual

Using Your Eos System

Wireless Receivers/Speakers ID Settings

English

All Eos Converge Transmitters, Wireless Speakers and Receivers have the same ID setting. This

is done so Receivers/Speakers will automatically link with any Converge Transmitter. The Con-

verge Transmitter will link with the first 4 Wireless Receivers/Speakers that it detects.

Linking Wireless Receivers/Speakers to a Specific Converge Transmitter

Due to the incredible range of the Eos system, it is possible for your speakers to receive audio

from a neighbors system. If this happens, or if you wish to run more than one Eos Wireless

System in your house, you can give your Converge Transmitters and the Receivers/Speakers

a unique ID. In giving your system a unique ID your Receivers/Speakers will link only to the

Converge Transmitter that they are paired to.

Setting a Unique ID

To give your Converge Transmitter and Receivers/Speakers a Unique ID, do the following:

1. Turn the power OFF on the Converge Transmitter

2. Turn OFF all power to the Wireless Receivers/Speakers that you wish to link.

3. Turn the power ON on the Converge Transmitter

4. Press and hold the “LINK” button on the bottom of the Converge Transmitter for 3

seconds until the “Link LEDs” on the Antenna mast starts blinking.

5. Turn on the Wireless Receivers/Speakers that you wish to link to this Converge Trans-

mitter within 60 seconds of pressing the “LINK” button.

ote: to link additional speakers once a unique ID has been set, refer to the “Adding a Speaker to a

System with a Unique ID” section on the following page.