User's Manual

Set Up

Wireless System Setup

The Eos Pro Series Wireless Speakers can receive wireless audio from either the EOSP-500 Dual

Zone Music Player with the EOSP-510 wireless transmitter card installed or from the EOSP-610

transceiver in the transmit mode. Transmitters are referred as TX in this manual and receivers as

RX.

Linking Wireless Transmitters & Wireless Speakers

Before initial use, you must link the wireless transmitter (TX) with the wireless speakers. Follow

the simple steps below to perform this linking procedure. You can link up to 8 wireless speak-

ers/transceivers (in receive mode) to the transmitter.

To simplify the process, it is recommend that you do the below process with the transmitter

and receivers in close proximity to each other to avoid having to run back and forth between

them.

Note - The receivers will retain their link to the transmitter, even after being powered down and

moved to their nal location.

Linking Procedure

(Note - linking procedure needs to be done on each wireless speaker receiver, one at a time)

1. Power on TX.

2. Using the IR Remote, power on speaker. The Power LED will be ON and the Link LED will

ash slowly.

3. Press the link button on the TX. The Status LED will ash quickly.

4. Press the link button of speaker. The Link LED will ash quickly.

5. If the pairing of TX and speaker is successful, the status LED of both TX and speaker will

be SOLID.

Note - If the pairing is not successful, after one minute, the status LED of the TX will go back to

ON and LED on the RX will return to ashing slowly.

Adding Additional Wireless Speakers/Receivers

After initial setup, you can add additional wireless speakers/transceivers (in RX mode) to the

system at any time by following the same procedure. When adding new wireless speakers/

transceivers to the system, you only need to perform the procedure on the new wireless speak-

ers/receivers.

TX Card

Link Button

Wireless Speaker

Link Button

Wireless Transceiver

Link Button

Set MODE

to TX