User's Manual

2.4.5. Step 4: Reviewing and Applying Settings

Fig. 8. Settings changes are highlighted in red.

On the start page, you can review all the settings you have made. Changes are highlighted in red. If

they are OK, click Restart to restart the AP for the new settings to take effect.

NOTE: About 7 seconds are needed for the AP to complete its restart process.

2.5. Deploying the AP

After the settings have been configured, deploy the AP to the field application environment. Connect

the AP to an Ethernet LAN through an Ethernet switch/hub.

If you are configuring a pair of the APs for a dynamic or static bridging application and external

high-gain directional antennas are used, it’s difficult to adjust alignments of the antennas when the

pair of devices is distance away.

To adjust the alignments of a pair of bridges’ directional antennas:

1. Connect each bridge to a computer via Ethernet.

2. Configure the date rate of each bridge to the lowest value, 1Mbps.