Quick Start Guide
Removing the Battery Pack Attaching the Battery Pack
1. Slide the Battery Lock
9
toward the outside edge of the
Power Converter
11
until it reaches the end of the slider.
2. Pull the Battery Pack
12
and the Power Converter
11
apart at the
center seam between the plug interface and Charging Port
7
.
1. Align the slots in the bottom of the Battery Pack
12
with the
hooks at the bottom of the Power Converter
11
and press the
halves together until the red / black contacts at the top intersect.
2. Slide the Battery Lock
9
away from the outside edge of the
Power Converter
11
until it reaches the end of the slider.
Power Converter Operation Charging the Battery Pack
1. With the Battery Pack
12
inserted rmly in the Power Converter
11
toggle the Power Switch
2
from “O” to “I” to turn the unit on.
2. Battery life is readable from the Battery Status Indicator
10
on the
Power Converter
11
while the Nomad is powered on.
• 3 dots = 50-100%
• 2 dots = 33-50%
• 1 dots ≤ 33%
1. Disconnect the Battery Pack
12
and remove the larger side of
the protective rubber plug from the Charging Port
7
.
2. Insert the end of your Nomad charger into the Charging Port
7
.
3. The LED on the Nomad charger transformer pack will glow red
while charging, and turn green upon completion. Charging will
take approximately 3.5 hours to fully charge one Battery Pack
12
.
Attaching Mounts & Clamps Removing Mounts & Clamps Replacing the Fuse
1. Locate the Mounting Plate
3
and align
the brackets of your clamp or mount
with the holes on the plate.
2. Press the brackets of your clamp or
third-party mount into the holes of the
Mounting Plate
3
and slide it toward the
Power Outlets
1
until it clicks.
1. Press the Mounting Plate Release
4
down and slide the brackets of your
mount away from the Power Outlets
1
.
2. Pull up on the clamp or mount and
remove it from the Mounting Plate
3
.
1. Set the Power Switch
2
to the OFF (“O”)
position and remove the Battery Pack
12
.
2. Firmly grip the 30A Fuse
6
with your
ngers or pliers and pull up to discard.
3. Take a new 30A fuse (included) and
carefully press it straight into the 30A
Fuse slot
6
until the base of the plastic
sheath sits ush with the device.
Information and Downloads
Visit our website at www.intertphotographic.com for a downloadable digital version of this guide and additional information about the
Nomad, as well as many other exciting Intert photo and video products to light your creativity.
Quick-Start Guide
Power Outlets Mounting Plate Release Charging Port Battery Status Indicator
Power Switch Ground Port 2A USB Port Power Converter
Mounting Plate 30A Fuse Battery Lock Battery Pack
1
2
3
4
5
6
7
8
9
10
11
12
2
3
4
5
6
8
9
10
7
12
11
1