User's Manual

These limits are part of comprehensive guidelines and establish permitted levels of

RF energy for the general population. The guidelines are based on standards that

were developed by independent scientific organizations through periodic and

thorough evaluation of scientific studies. The standards include a substantial safety

margin designed to assure the safety of all persons, regardless of age and health. The

exposure standard for wireless mobile phones employs a unit of measurement

known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6

W/kg. * Tests for SAR are conducted with the phone transmitting at its highest

certified power level in all tested frequency bands. Although the SAR is determined

at the highest certified power level, the actual SAR level of the phone while operating

can be well below the maximum value. This is because the phone is designed to

operate at multiple power levels so as to use only the power required to reach the

network. In general, the closer you are to a wireless base station antenna, the lower

the power output. Before a phone model is available for sale to the public, it must be

tested and certified to the FCC that it does not exceed the limit established by the

government adopted requirement for safe exposure. The tests are performed in

positions and locations (e.g., at the ear and worn on the body) as required by the FCC

for each model. The highest SAR value for this model phone when tested for use at

the ear is 0.877W/Kg and when worn on the body, as described in this user guide, is

1.176W/Kg(Body-worn measurements differ among phone models, depending upon

available accessories and FCC requirements). The maximum scaled SAR in hotspot

mode is 1.176 W/Kg. While there may be differences between the SAR levels of

various phones and at various positions, they all meet the government requirement

for safe exposure. The FCC has granted an Equipment Authorization for this model

phone with all reported SAR levels evaluated as in compliance with the FCC RF

exposure guidelines. SAR information on this model phone is on file with the FCC and

can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after

searching on

FCC ID:2AC7IEKO-A35G Additional information on Specific Absorption Rates (SAR) can

be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at

http://www.wow-com.com. * In the United States and Canada, the SAR limit for mobile

phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The

standard incorporates a sub-stantial margin of safety to give additional protection for the

public and to account for any variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure

requirements, a minimum separation distance of 10mm must be maintained between the

user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and

similar accessories used by this device should not contain any metallic components.

Body-worn accessories that do not meet these requirements may not comply with RF

exposure requirements and should be avoided. Use only the supplied or an approved

antenna.