Assembly Instructions
Office Partitions
Assembly
Instructions
Customer Service
1-800-645-2986
Low-Hi (90˚)
3 - W ay Connector
Straight Extension
Hi-Low (90˚)
Right/Left Connector
90˚ Connector
S c r e w
Adjust all levelers to
approximately 1-1/4”
H7
HARDWARE
A S S E M B LY
• Configurations require the corresponding
steps needed for proper assembly.
• Attach appropriate brackets or legs on
the ends of the panels as needed.
• Panels must be level. Level each panel.
• Do not attach bolts or brackets into the
outermost edge of a panel that will be last
in line.
• Starter panel should use a corner, 3-way,
4 - w a y, or wall bracket.
• Insert bolt cap into unused threaded
insert to finish your project.
• Level each panel as you go along.
H8 H9 H10 H11
Panel Filler Cap Panel Filler PostHex Bolt Threaded Stud Bolt Cap
H13 H14 H15 H16 H17
Toggle Bolt
H12
1
Straight Connector 3-way ConnectorWall Bracket
Right A n g l e
(90˚) Connector
4-way Connector
H1 H2 H3 H4 H5
T- L e g
H6
WARNING
In order to prevent structural failure, instability,
t i p - o v e r, and/or serious injury, please follow
i n s t r uctions care f u l l y. Do not use hanging shelf or
o v e r head cabinet with panels that have glass.
• Use only the instructions, parts and
hardware included
• Maximum span for connected
panels without support is 12 feet
• Do not move panels while they are connected together
• Maximum span for connected
panels using overhead cabinets or
shelves without support is 12 feet
• Requires 2 people for assembly
• Not for outdoor or high humidity areas
12’
12’
12’
12’
O v e r h e a d
C a b i n e t s
O v e r h e a d
S h e l v e s