Assembly Instructions

149 ENTIN ROAD, CLIFTON, NJ 07014 | TEL [phone] | FAX [phone]
National Public
SEATING Corp.
If you encounter any difficulties assembling your caddy, call Customer Service at 973-594-1100
CAUTION: Children under 12 are prohibited from using this product without the supervision of an adult.
STEP 2
STEP 5
A
A
C
STEP 3
STEP 5
B
STEP 4
STEP 6
B
D
D
STEP 4
STEP
5
ASSEMBLING UNIT WITH
OPTIONAL EXT-8 EXTENDED BAR*
ASSEMBLY
STEP 1) Ascertain that there are NO missing
or damaged parts.
STEP 2) While holding up one side of
the “T” side-bar (Part A), bolt
crossbeam (part B) into the middle
set of holes. NOTE: There are three
holes. Use the upper two holes.
STEP 3) Take the other side “T’ bar (Part
A), and bolt it to crossbeam (part
B) in the middle set of holes.
STEP 4) Take one EXT-8 bar (Part D) and
place the wider part over the top
of the “T” bar (Part A). Align the
two holes of the EXT-8 bar with
the holes of the “T” bar and bolt
them in.
STEP 5) Take the other EXT-8 bar (Part D)
and do the same to the other “T”
bar.
STEP 6) Take the other crossbeam (Part B),
and bolt it to the set of holes on top
of the EXT-8 bar.
STEP 7) Finally, bolt crossbeam (Part C),
into the bottom sets of holes on
both “T” side-bars (Parts A).
STEP 8) Remove the end caps from the
bag, and using a rubber mallet,
attach them to the ends of the chair
hangers.
*The EXT-8 Extender Bar should be used to
accommodate the following NPS chairs:
3200 Series; 1000 Series; Model 602
e-mail: [e-mail]