- Interlink Electronics Multimedia Projector Operator's Guide X70/X80

Lamp (continued)

After making sure that the projector has cooled

adequately, slide the knob of a lamp door lock as

shown in the Figure. Then, one side of the lamp door

is raised. Pull up the lamp door and remove it, as

shown in the Figure.

If the indicators or a message prompts you to replace the lamp, replace the lamp as soon

as possible.

Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at

least 45 minutes.

Contact your dealer to prepare a new lamp. Tell the dealer your lamp type number.

If the projector is mounted on the ceiling, or if the lamp has broken, also ask the

dealer to replace the lamp.

Unscrew the 3 screws, and slowly pull out the lamp

by the handle. Be careful not to touch the inside of

the lamp case.

Insert the new lamp, and tighten the 3 screws firmly

to lock it in place.

Interlocking the 2 tabs of the lamp door to the

projector, put the lamp door on the projector. Then

push the point of the lamp door to fix it, as shown in

the Figure. Make sure that the lamp door doesn’t

come up.

Turn on the projector, and reset the lamp timer.

(1) While the projector running, press the MENU button to open the menu.

(2) Choose the “OPTION” on the menu using the

button, then press the

button or ENTER button.

(3) Choose the “LAMP TIME” using the

button, then press and hold the

RESET button for 3 seconds.

(4) Choose the “RESET” using the button.

memo When the lamp has been replaced after the message of "THE POWER WILL

TURN OFF AFTER 0hr." is displayed, complete this operation within 10 minutes of

switching power on.

memo Incorrectly resetting of the lamp timer (resetting without replacement, or

neglect of resetting after replacement) will result in incorrect message functions.

Lamp door

knob

Tabs

In the case of replacement by yourself,

Screws

Replacing The Lamp

•

Do not use the projector with the lamp door removed. At the lamp replacing, make

sure that the screws are screwed in firmly. Loose screws could result in damage or injury.

NOTE