Owner's manual

ManualsBrandsInterlogix ManualsSensors5812A Series (SPRES)

SENTROL

ShatterPro

™

Residential Advanced Acoustic Sensor

with Pattern Recognition Technology

™

Protected under U.S. Patent 5,192,931 and 5,510,767

Installation Instructions for Surface Mount Models

Description Model No. Color

ShatterPro

™

Residential EZ, non-latch LED SPRES-EZ White

ShatterPro

™

Residential, non-latch LED SPRES White

Hand-held Tester, for testing effective range 5709C-W White

Strip back the outer jacket on your wiring cable. This will allow wires to flex in the case. Make sure the cable is slack in the wall to

avoid stressing the wires at their connections.

Surface Mount ShatterPro™ II

Residential SPRES-EZ

Surface Mount ShatterPro™ Residential SPRES

–

N.C.

COM

SPRES/SPRES-EZ

ORDERING INFORMATION

WIRING

Summary of content (4 pages)

PAGE 1
SENTROL ShatterPro™ Residential Advanced Acoustic Sensor with Pattern Recognition Technology™ Protected under U.S. Patent 5,192,931 and 5,510,767 Installation Instructions for Surface Mount Models Surface Mount ShatterPro™ Residential SPRES Surface Mount ShatterPro™ II Residential SPRES-EZ WIRING Strip back the outer jacket on your wiring cable. This will allow wires to flex in the case. Make sure the cable is slack in the wall to avoid stressing the wires at their connections. – + N.C.
PAGE 2
RANGE OF COVERAGE 25' (7.5 m) 25' (7.5 m) ShatterPro sensors are omni-directional, providing 360° coverage. Coverage is measured from the sensor to the point on the glass farthest from the sensor. The sensor can be mounted as close as 3.3' (1 m) from the glass. 1. Mounted on opposite wall or adjoining walls, range is 25 ft. (7.5m) for plate, tempered, laminated and wired glass. 2. Mounted on the ceiling, maximum range is 25 ft. (7.5m) for plate, tempered, laminated and wired glass. 3.
PAGE 3
MOUNTING Locate sensor at least 4' from noise sources (TVs, speakers, sinks, Ceiling Mounting doors, etc.), and at least 3.3' away from nearest point of glass to Mount the sensor in any type of ceiling in a location which is in be protected. direct line of sight of the windows to be protected. However, since Sensor location should be in direct line of sight of glass to be sound travels directionally out from the broken window, a position protected. Glassbreak sensors cannot reliably detect breaking 8' (2.
PAGE 4
SPECIFICATIONS Electrical Voltage ...................................................................... 9 to 16 VDC Current ............................................... 12 mA typical, 25 mA max. Relay output ............ Normally closed, open 4 seconds upon alarm On resistance ................................................ 10 Ohm 5 +10 Off resistance ....................................................... > 1 MOhms Maximum loop rating (relay or tamper loop) ......................... ................