Installation Manual

2 / 3 AdvisorOne 3G Antenna Installation Sheet
Installing the AdvisorOne 3G Antenna into the AdvisorOne panel
1. Carefully connect the Antenna cable (B in Figure 2) to the Advisor Cellular Modem connector (C in Figure 2) by pressing firmly
into the connector until hearing a click.
2. Route the antenna cable (B in Figure 2) on top of the communications cover (ensure the knockout of the communication has
been removed) alongside the battery (D in Figure 2) and inside the battery strap (E in Figure 2). Continue routing the antenna
cable through the cut out as shown in Figure 2.
3. Fasten the battery strap, securing both the antenna cable and the battery.
4. In order to attain maximum RF performance, the antenna must be fully extended away from the panel. Reposition the antenna
if there is a decline in RF performance.
• If attaching the antenna to a wall, fully extend the cable/antenna, remove the adhesive backing and mount the antenna so
that it is away from the panel.
• If placing cable/antenna behind a wall, fully extend the cable/antenna so that it is away from the panel.
5. Complete the installation procedure, starting with step 6 in the Advisor Cellular Modem Installation Sheet (P/N 466-4412).
Specifications
Compatibility
Advisor Cellular Modem, AdvisorOne Panel
Dimensions
1” x 5.8” x .3” (25.4 mm x 147.3 mm x 7.6 mm)
Operating Frequency
850, 900, 1800, 1900 MHz
Regulatory Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by UTC Fire and Security Americas Corporation, Inc. could void the user’s
authority to operate the equipment.
In accordance with FCC requirements of human exposure to radiofrequency fields, the radiating element shall be installed such that
a minimum separation distance of 20 cm is maintained from the general population.
FCC: B4Z-944-3G
IC: 1175C-944E3G
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference,and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux
conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y
compris celles pouvant causer un mauvais fonctionnement de l'appareil.