Installation Manual Instruction Manual

Appendix B: Reference tables
136 Concord 4 Installation Manual
System event triggers
Table 26 below describes the system event triggers.
Table 26: System event trigger
System event
Description
Trigger
number
Null trigger (used for direct control)
Activates only by schedule or direct command.
000
Fire alarm
When fire sirens are started.
001
Police alarm
When police sirens are started.
002
Auxiliary alarm
When auxiliary sirens are started.
003
Any audible alarm
When any of the above sirens are started.
004
Silent alarm (sensor groups 2, 3,
and duress)
When a group 2 or 3 sensor goes into alarm or
when a duress alarm is activated (does not
include groups 25, 27, 28, or 32).
005
Any audible or silent alarm
When any alarm is started (does not include
groups 25, 27, 28, or 32).
006
HOM group 27, 28, 32 in alarm
When a sensor in group 27, 28, or 32 goes
into alarm.
007
Major trouble (phone or receiver
failure)
When a receiver failure (S94) or a phone
failure (S96) occurs.
008
Arming to stay or away
When the system is armed to level 2 or 3.
009
Arming to away
When the system is armed to level 3.
010
AVM is interactive (audio session
in progress)
When the central station operator begins
listening or talking to the premises.
011
Fail-to-communicate (panel can’t
call CS or pager)
When the fail-to-communicate output is
activated.
012
AVM trip (edge)
When an AVM alarm occurs, output is
activated momentarily.
013
Keychain touchpad star button-
press
When the star button on a keychain touchpad
is pressed.
014
Smoke power (for resetting four-
wire smoke detectors)
Deactivated when hardwire smoke detectors
need to be reset.
015
Exterior siren
Activated for police or fire alarms.
016
Interior siren
Activation follows all system noises
017
AVM trip (pulse)
When an AVM alarm occurs, output is
deactivated for 10 ms
018
State of system status
Follows the state of system status (ready or
trouble).
019
Tamper condition
When any tamper is tripped
020