Installation Manual Instruction Manual

Chapter 3: Programming
Concord 4 Installation Manual 47
Keyfob PTN
Shortcut: 0006
Default: On
This feature controls which partitions the selected keyfob can
arm/disarm. When enabled, the selected keyfob can arm/disarm the
partitions selected in this menu. When disabled, the selected keyfob
cannot arm/disarm multiple partitions. For this feature:
If no keyfobs are learned into panel memory, the menu displays
NOT AVAILABLE. When keyfobs are learned into panel memory,
two submenus appear. The first one lets you view keyfob assignments
similar to that of viewing learned sensors. The second submenu lets
you view and change the multipartition arming assignments for that
keyfob.
At least two partitions must be selected.
Keyfobs can arm/disarm multiple partitions only for those partitions
set up in the Multipartition arm/disarm menu.
A partition cannot be armed/disarmed if it is being controlled by
another source at that time.
When arming multiple partitions from a keyfob, any conditions that
prevent arming are identified on touchpad displays in the partition
where that condition exists. Touchpad displays in all other partitions
being armed display PROTEST. The normal protest/auto force arm
sequence follows, or pressing * on any touchpad in a partition being
armed cancels the arming request. Pressing the Lock button again
during a protest bypasses any open sensors in the affected partitions
and arms those partitions.
When disarming multiple partitions with a keyfob and alarms are
active in one or more of the assigned partitions, protest beeps sound
for 5 minutes in all partitions being disarmed; partitions in alarm where
sirens have timed out sound protest beeps for 5 minutes; and
partitions in alarm with active sirens continue sounding the alarm.
In any case where alarms are active the premises may not be safe to
enter. The user has these options: leave and call for help from a safe
location; if entering the premises anyway, go to a hardwired touchpad
and check the system status to determine the alarm. Disarm and
alarm memory is displayed for all assigned partitions; and press the
keyfob Unlock button a second time (within the 5-minute protest
period) to disarm all assigned partitions and cancel all alarms, then go
to a hardwired touchpad and check alarm memory.
To enable keyfob PTN:
1. Learn all keyfobs into panel memory. (See “Sensors menuon page
67.)
2. Enter this menu (display showing KEYFOB TP PTN), then press
#. The display shows the lowest touchpad sensor number assignment
such as: S1 P1 G0 TP RF where S1 is sensor 1, P1 is partition
1, G0 is sensor group 0, TP is touchpad and RF is wireless.
3. Press # to accept this keyfob or press A or B until the desired
keyfob appears, then press #. The display shows ARM
PARTITION.
4. Enter the desired partitions 1 to 6 (at least two). The display flashes
the entered partitions.