Installation Manual Instruction Manual

Chapter 3: Programming
Concord 4 Installation Manual 73
Accessory modules menu
The Accessory modules menu gives you access to the following menus:
Bus devices: Use these settings to read bus device unit numbers, assign bus
devices to a partition, and configure other features associated with a specific bus
device. (Most bus device settings do not have shortcut numbers).
SnapCards: Use these settings to set the configuration number for each
SnapCard output, assign SnapCard outputs to a partition, and name the
SnapCard outputs.
Accessory modules - bus device settings
Unit-ID
Shortcut: 10000 to
10015
Default: **** or None
This menu lets you identify all connected bus devices, view each unit
number, view the device ID number, and configure other settings based
on a specific device. This menu also lets you delete learned bus
devices.
To help identify bus devices, the 8-digit device ID number is also located
on a label on each SuperBus 2000 device.
To identify bus device unit and ID:
1. With the display showing BUS DEVICES, press #. The display
shows the bus unit number and the 8-digit device ID number. For
example: UNIT - ID 0—02110185. Where 0 is the unit number
and 02110185 is the device ID number.
2. Press A or B to identify all other bus unit numbers (0 to 15) and
device ID numbers.
To delete learned unit numbers:
1. With the display showing BUS DEVICES, press #. The display
shows the bus device set to unit number 0.
2. Press A or B until the bus device unit number you want to delete is
displayed.
3. Press D. The display changes the unit number to None.