Installation Manual Instruction Manual

Chapter 3: Programming
80 Concord 4 Installation Manual
Onboard options - output text settings
Output text
Shortcut: 1120 to 1121
Default: None
Entering text for an output allows you to control it directly or by
schedule. Use the following guidelines to name onboard outputs:
• Use the item numbers listed in Table 25 on page 134 for characters
and words.
• If you want to configure an output for user output control you must use
the output text feature to name the output. If no output text is
programmed, output control will not function for that output.
• If a desired word does not appear in Table 25 on page 134, create it
using the characters (custom text).
• When using words from the table, spaces between them appear
automatically. When using characters from the table to create words,
you must reserve an item number for a space after the word.
• Each character or word uses up one item number. For example, a
word from the list counts as one item number.
• Only 16 item numbers are allowed for each output name, so plan
before programming output text. You may need to abbreviate words to
avoid running out of item numbers.
To program output text:
1. With the display showing ONBOARD OPTIONS, press # then press
B twice and the display shows OUTPUT TEXT.
2. Press # and the display shows OUTPUT 1.
3. Press #and the display shows: OUTPUT 1 ITEM 0 0 -. Where
ITEM 0 is the first character or word location and 0 is the character or
word number.
4. Enter the number of the character or word, or scroll through the
numbers by pressing B (forward) or A (backward). If you make a
mistake, enter the correct number or continue scrolling through choices.
5. Press # to accept the displayed choice and the display shows
OUTPUT 1 ITEM 1 0 -.
6. Repeat the process as needed to complete the output name.
7. Press * after entering the last character or word number. The display
shows the complete text name. For example, OUTPUT 1 GARAGE
DOOR.