Installation Manual Instruction Manual

Chapter 3: Programming
82 Concord 4 Installation Manual
User programming mode
The user programming mode allows you to view system version information and
program system settings. You can enter user programming from an
alphanumeric or fixed display touchpad by using the system or partition master
code. The default system master code is 1234. To enter user programming
mode, press 9, code. The display shows TIME AND DATE. The default settings
are shown in brackets in the table where applicable.
Table 13: User programming menus
Time and date
Time
Date
User codes
Regular user
User 00
Direct bypassing [Off]
Remote access [Off]
System test [Off]
Latchkey report [Off]
Partition assign [1]
Partition master
Partition master code [None]
System master
System master code [1234]
Options
Downloading [On]
Touchpad brightness [2]
Volume [4]
Voice chime [On]
Chime on close [Off]
Set up schedules
Schedule 00 to 15
Start time [00:00]
Stop time [00:00]
Monday [Off]
Tuesday [Off]
Wednesday [Off]
Thursday [Off]
Friday [Off]
Saturday [Off]
Sunday [Off]
Attach schedule to
events
Latchkey opening
Schedule 00 to 15 [Off]
Latchkey closing
Schedule 00 to 15 [Off]
Exception opening
Schedule 00 to 15 [Off]
Exception closing
Schedule 00 to 15 [Off]
Lights 1 to 9
Schedule 00 to 15 [Off]
Output 1 to 6
Schedule 00 to 15 [Off]
Arming
Schedule 00 to 15 [Off]