Installation Manual Instruction Manual

Chapter 1: Introduction
Concord 4 Installation Manual 3
Built-in RF receiver
Allows use of up to 96 (Concord 4) or 32 (Concord Express v4)
319.5 MHz. crystal and/or SAW learn mode wireless sensors and
touchpads.
Phone line connection
Allows panel to communicate with central monitoring station and/or
pagers.
SuperBus 2000 bus devices
The following components can be used with the Concord 4 panel:
Table 3: SuperBus devices
Touchpads
Use the following touchpads for installer/user programming
and system operation.
SuperBus 2000 2x16 LCD touchpad
SuperBus 2000 2x20 LCD touchpad
SuperBus 2000 2x20 VFD touchpad
SuperBus 2000 ATP 1000 touchpad
SuperBus 2000 ATP 2100 touchpad
SuperBus 2000 ATP 2600 touchpad
Use the following touchpads for installer quick programming,
system operation and user programming:
SuperBus 2000 fixed display touchpad
SuperBus 2000 FTP 1000 touchpad
SuperBus 2000 RF transceiver
Use the transceiver to receive signals from sensors and
touchpad that may be on the fringe of panel reception. The
transceiver is compatible with all 319.5 MHz crystal and SAW
learn mode wireless sensors and touchpads.
Power line carrier transformer
Allows the use of X10 powerhouse lamp modules for light
control and light activation during alarms.
SuperBus 2000 voice only
module
Provides an output for a speaker that sounds system status
and alarm voice messages.
SuperBus 2000 phone
interface/voice module
Allows system access and control using touchtone
telephones, onsite or offsite. The module includes an output
for a speaker that sounds system status and alarm voice
messages