Installation Manual Instruction Manual

Chapter 3: Programming
88 Concord 4 Installation Manual
Set up schedules menu
The set up schedules menu lets you set up timeframes for light control, output
control, automatic arming, latchkey times, and exception opening/closing reports.
The system (all partitions) allows you to set up to 16 schedules (00 to 15) that
are shared by all partitions.
Setting up schedules consists of setting a start and stop time for each schedule,
then selecting which days of the week the schedule will be active. You can also
set up a rollover schedule, which starts on one day and ends on another day.
This saves programming time and leaves more schedules available (in case they
are needed later).
For example, to set up a schedule to rollover from Tuesday evening to
Wednesday morning, set a schedule start time for 2200 (10:00 p.m.) and a stop
time for 0500 (5:00 a.m.). Set the schedule to turn on Tuesday. Because the stop
time is set for morning, the system automatically carries the schedule over to the
next day.
If you use the same start and stop times described above and set the schedule to
turn on Monday through Friday, then one schedule will cover the entire week.