User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
106 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
QoS Policy and Priority Type
Here you can choose to use an 8-4-2-1 queuing scheme or a strict priority scheme, or
select the priority type to configure QoS policy.
Figure 5-49: QoS Configuration interface
This page includes the following fields:
Object Description
Qos Policy:
Select the QoS policy rule.
Using the 8,4,2,1 weight fair queue scheme: The switch will follow
8:4:2:1 rate to process priority queue from High to lowest queue.
For example, while the system processing, 1 frame of the lowest
queue, 2 frames of the low queue, 4 frames of the middle queue, and
8 frames of the high queue will be processed at the same time in
accordance with the 8,4,2,1 policy rule.
Use a strict priority scheme: Always the higher queue will be
processed first, except the higher queue is empty.
Priority Type:
There are 5 priority type selections available—
Port-based
TOS only
COS only
TOS first
COS first
Disable means no priority type is selected.