User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 123
This page includes the following fields:
Object Description
IEEE 802.1x Protocol: Enable or disable 802.1x protocol.
Radius Server IP: Assign the RADIUS Server IP address.
Server Port:
Set the UDP destination port for authentication requests to the
specified RADIUS Server.
Accounting Port:
Set the UDP destination port for accounting requests to the
specified RADIUS Server.
Shared Key:
Set an encryption key for using during authentication sessions with
the specified RADIUS server. This key must match the encryption
key used on the RADIUS Server.
NAS, Identifier: Set the identifier for the RADIUS client.
Port Configuration
You can configure the 802.1x authentication state for each port. The state provides
Disable, Accept, Reject, and Authorize.
Figure 5-66: 802.1x Per Port Setting interface