User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
124 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
This page includes the following fields:
Object Description
Reject: The specified port is required to be held in the unauthorized state.
Accept: The specified port is required to be held in the authorized state.
Authorize:
The specified port is set to the Authorized or Unauthorized state in
accordance with the outcome of an authentication exchange
between the Supplicant and the authentication server.
Disable:
When disabled, the specified port works without complying with
802.1x protocol.
Port Configuration
You can configure the 802.1x authentication state for each port. The state provides
Disable, Accept, Reject, and Authorize.
Figure 5-67: 802.1x Misc Configuration interface