User Manual

Chapter 6: Command Sets
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 141
Commands Level Description Example
giga ports,
and zero means no limit.
bandwidth out [Value] Set interface output
bandwidth. Rate Range is
from 100 kbps to 102400
kbps or to 256000 kbps for
giga ports,
and zero means no limit.
switch(config)#interface fastEthernet
2
switch(config-if)#bandwidth out 100
Show bandwidth I Show interfaces bandwidth
control
switch(config)#interface fastEthernet
2
switch(config-if)#show bandwidth
State [Enable | Disable] I Use the state interface
configuration command to
specify the state mode of
operation for Ethernet ports.
Use the disable form of this
command to disable the
port.
switch(config)#interface fastEthernet
2
switch(config-if)#state Disable
show interface
configuration
I show interface configuration
status
switch(config)#interface fastEthernet
2
switch(config-if)#show interface
configuration
show interface status I show interface actual status switch(config)#interface fastEthernet
2
switch(config-if)#show interface
status
show interface
accounting
I show interface statistic
counter
switch(config)#interface fastEthernet
2
switch(config-if)#show interface
accounting
no accounting I Clear interface accounting
information
switch(config)#interface fastEthernet
2
switch(config-if)#no accounting