User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 6: Command Sets
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 143
VLAN Commands Set
Commands Level Description Example
vlan database P Enter VLAN configure mode switch#vlan database
Vlanmode
[portbase| 802.1q | gvrp]
V To set switch VLAN mode. switch(vlan)#vlanmode portbase
or
switch(vlan)#vlanmode 802.1q
or
switch(vlan)#vlanmode gvrp
no vlan V No VLAN Switch(vlan)#no vlan
Ported based VLAN configuration
vlan port-based grpname
[Group Name]
grpid
[GroupID]
port
[PortNumbers]
V Add new port based VALN switch(vlan)#vlan port-based
grpname test grpid 2 port 2-4
or
switch(vlan)#vlan port-based
grpname test grpid 2 port 2,3,4
show vlan [GroupID]
or
show vlan
V Show VLAN information switch(vlan)#show vlan 23
no vlan group
[GroupID]
V Delete port base group ID switch(vlan)#no vlan group 2
IEEE 802.1Q VLAN
vlan 8021q name
[GroupName]
vid
[VID]
V Change the name of VLAN
group, if the group didn’t
exist, this command can’t be
applied.
switch(vlan)#vlan 8021q name test
vid 22
vlan 8021q port
[PortNumber]
access-link untag
[UntaggedVID]
V Assign a access link for
VLAN by port, if the port
belong to a trunk group, this
command can’t be applied.
switch(vlan)#vlan 8021q port 3
access-link untag 33