User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 6: Command Sets
150 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
SNMP Commands Set
Commands Level Description Example
snmp system-name
[System Name]
G Set SNMP agent system
name
switch(config)#snmp system-name
l2switch
snmp system-location
[System Location]
G Set SNMP agent system
location
switch(config)#snmp system-location
lab
snmp system-contact
[System Contact]
G Set SNMP agent system
contact
switch(config)#snmp system-contact
where
snmp agent-mode
[v1v2c|v3|v1v2cv3]
G Select the agent mode of
SNMP
switch(config)#snmp agent-mode
v1v2cv3
snmp community-
strings [Community]
right
[RO/RW]
G Add SNMP community string.
switch(config)#snmp community-
strings public right rw
snmp-server host
[IP address]
community
[Community-string]
trap-version
[v1|v2c]
G Configure SNMP server host
information and community
string
switch(config)#snmp-server host
192.168.1.50 community public trap-
version v1
(remove)
Switch(config)#
no snmp-server host
192.168.1.50
snmpv3 context-name
[Context Name ]
G Configure the context name switch(config)#snmpv3 context-name
Test
snmpv3 user
[User Name]
group
[Group Name]
password
[Authentication
Password] [Privacy
Password]
G Configure the userprofile for
SNMPV3 agent. Privacy
password could be empty.
switch(config)#snmpv3 user test01
group G1 password AuthPW PrivPW