User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 6: Command Sets
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 161
PoE Command Set
Commands Level Description Example
poe P Configure PoE function switch# poe
exit PoE Exit the PoE command mode
switch(poe)# exit
port [PortNumber] state
[Enable | Disable]
Set PoE port State switch(poe)# port 1 state enable
port [PortNumber] plfc
[Enable | Disable]
PoE Set PoE port Power Limit
from Classification
switch(poe)# port 1 plfc enable
port [PortNumber]
legacy
[Enable | Disable]
PoE Set PoE port Legacy switch(poe)# port 1 legacy enable
port [PortNumber]
priority
[Low|High|Critical]
PoE Set PoE port Priority switch(poe)# port 1 priority critical
port [PortNumber]
powerlimit [Value]
PoE Set PoE port Power Limit
Value
switch(poe)# port 1 powerlimit 10
system PoE Configure PoE System switch(poe)# system
system knockoff-
disabled
[Enable | Disable]
PoE Set PoE system Port
Knockoff Disabled
switch(poe)# system knockoff-
disabled enable
system ac-disconnect
[Enable | Disable]
PoE Set PoE system AC
Disconnect
switch(poe)# system ac-disconnect
enable
system capacitive-
detect
[Enable | Disable]
PoE Set PoE system Capacitive
Detection
switch(poe)# system capacitive-
detect enable
system power-limit
[Value]
PoE Set PoE system System
Power Limit
switch(poe)# system power-limit 100