User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 171
Appendix A
RJ-45 Pin Assignment
Switch's RJ-45 Pin Assignments
1000Mbps, 1000Base T
Contact MDI MDI-X
1 BI_DA+ BI_DB+
2 BI_DA- BI_DB-
3 BI_DB+ BI_DA+
4 BI_DC+ BI_DD+
5 BI_DC- BI_DD-
6 BI_DB- BI_DA-
7 BI_DD+ BI_DC+
8 BI_DD- BI_DC-
Implicit implementation of the crossover function within a twisted-pair cable, or at a
wiring panel, while not expressly forbidden, is beyond the scope of this standard.