User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 2: Installation
14 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
The Front Panel and Rear Panel of the GE-DSH-82-PoE Managed Industrial Switch are
shown below:
Figure 2-5: Front and Rear Panel of GE-DSH-82-PoE
1. Model Name 9. 10/100/1000Base-T port
2. System Power: LED 10. 1000Base-SX/LX SFP slot
3. Ring Master: LED indicator 11. LED indicators for 1000Base-SX/LX ort
4. LED for power 1 input 12. LED indicators for PoE power output
5. LED for power 2 input 13. 6-Pin Terminal Block
6. FAULT: LED indicator 14. Ground Screw
7. RJ-45 type RS-232 Console 15. Screw holes for Wall Mounting kit
8. 8 x 10/100Base-TX port 16. DIN-Rail Kit