User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 2: Installation
GE-DSH-73/DSH-82 and DSH-82-PoE User Manual 21
GE-DSH-82-PoE LED Indicators
• System
LED Color Status Meaning
On The switch unit is power on.
PWR Green
Off No power.
On The industrial switch is the master of X-Ring group.
R.M. Green
Off
The industrial switch is not a ring master in X-Ring
group.
On Power 1 is active.
PWR1 Green
Off Power 1 is inactive.
On Power 2 is active.
PWR2 Green
Off Power 2 is inactive.
On Power or port failure.
FAULT Red
Off No failure.
• 10/100Base-TX Ports – Port-1 to Port-8
LED Color Status Meaning
On A network device is detected.
Blinking
The port is transmitting or receiving packets from
the TX device.
Green
Off No device attached.
On The port is operating in full-duplex mode.
Blinking Collision of Packets occurs.
Port-1 ~ Port-8
Amber
Off
The port is in half-duplex mode or no device is
attached.