User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 2: Installation
22 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
• PoE port link – Port-1 to Port-8
LED Color Status Meaning
On An IEEE 802.3af PoE power device is detected. FWD
(P1 to P8)
Green
Off No IEEE 802.3af PoE power device attached
• 10/100/1000Base-T / SFP combo interface - Port-9, Port-10
LED Color Status Meaning
On A network device is detected.
Blinking
The port is transmitting or receiving packets from
the TX device.
Green
(Upper LED)
Off No device attached
On 1000M
Port 9, Port 10
(RJ-45)
Green
(Lower LED)
Off 10/100M
On The SFP port is linking
Blinking
The port is transmitting or receiving packets from
the TX device.
Link/Active (P9,
P10 SFP)
Green
Off No device attached