User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
48 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
IP Configuration
The IP Configuration includes the IP Address, Subnet Mask and Gateway. The
Configured column is used to view or change the IP configuration. Fill up the IP
Address, Subnet Mask and Gateway for the device. The screen in Figure 5-4 appears.
Figure 5-4: IP configuration interface
This page includes the following fields:
Object Description
DHCP Client:
Enable or disable the DHCP client function. When DHCP client function is
enabled, the switch will be assigned an IP address from the network
DHCP server. The default IP address will be replaced by the assigned IP
address on DHCP server. After the user clicks Apply, a popup dialog
shows up to inform the user that when the DHCP client is enabled, the
current IP will lose and user should find the new IP on the DHCP server.
IP Address:
Assign the IP address that the network is using. If DHCP client function is
enabled, this switch is configured as a DHCP client. The network DHCP
server will assign the IP address to the switch and display it in this
column.
The default IP is 192.168.0.100 or the user has to assign an IP address
manually when DHCP Client is disabled.
Subnet Mask:
Assign the subnet mask to the IP address. If DHCP client function is
disabled, the user has to assign the subnet mask in this column field.
Gateway:
Assign the network gateway for the switch. If DHCP client function is
disabled, the user has to assign the gateway in this column field.
The default gateway is 192.168.0.1.
DNS1: Assign the primary DNS IP address.
DNS2: Assign the secondary DNS IP address.