User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
56 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
System Event Log-SMTP Configuration
Simple Mail Transfer Protocol (SMTP) is the standard for email transmissions across
the network. You can configure the SMTP server IP, mail subject, sender, mail account,
password, and the recipient email addresses, which the e-mail alert will send to.
There are also five types of event-Device Cold Start, Device Warm Start,
Authentication Failure, X-Ring Topology Change, and Port Event-available to be
issued as the e-mail alert. Besides, this function provides the authentication
mechanism including an authentication step through which the client effectively logs
in to the SMTP server during the process of sending e-mail alert.
Figure 5-12: SMTP Configuration interface
This page includes the following fields:
Object Description
Email Alert:
With this function being enabled, the user is allowed to configure the
detail settings for sending the e-mail alert to the SMTP server when
the events occur.
SMTP Server IP:
Assign the mail server IP address (when Email Alert is enabled, this
function will then be available).
Sender:
Type in an alias of the switch in complete email address format, e.g.,
to identify where the e-mail alert comes from.